Bimba IntelliSens Uživatelský manuál stáhnout pdf (Strana 44)

IntelliSense

Manual

4096 Retract time was above limit

2048 Retract time was below limit

1024 Extend time was above limit

512 Extend time was below limit

256 Sensor 2 Temperature is below limit

128 Sensor 1 Temperature is below limit

64 Sensor 2 Temperature is above limit

32 Sensor 1 Temperature is above limit

16 Rod Seal Failure Present

8 Front Piston Seal Failure Present

4 Rear Piston Seal Failure Present

2 Line pressure above limit

1 Line pressure below limit

• Avalueof16meanstheeventwastriggeredbytheretracttimewindowchanginginthepositivedirection

equal or greater than the value of the “Extend/Retract time” change parameter.

• Avalueof32meanstheeventwastriggeredbytheretracttimewindowchanginginthenegativedirection

equal or greater than the value of the “Extend/Retract time” change parameter.

• Avalueof64meanstheeventwastriggeredbyanincreaseindetectedrodsealleakage,inpercentage,

equal to or greater than the value of the “Cylinder leak” change parameter.

• Avalueof256meanstheeventwastriggeredbyanincreaseindetectedfrontpistonsealleakage,inper-

centage, equal to or greater than the value of the “Cylinder leak” change parameter.

• Avalueof1024meanstheeventwastriggeredbyanincreaseindetectedrearpistonsealleakage,inper-

centage, equal to or greater than the value of the “Cylinder leak” change parameter.

Events Failures

When an event is logged by the SIM unit, it records any active failures. These failures are coded as binary numbers as

follows:

Following this table, a failure code for “Extend time was above limit” would be a 1024. Likewise, an event with mul-

tiple failures, such as a “Extend time was above limit” and “Line pressure above limit” would be a 1026.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 67 68

Žádné komentáře

Bimba IntelliSens Uživatelský manuál Strana 44