Bimba PCS Uživatelský manuál stáhnout pdf (Strana 34)

www.bimba.com Technical Assistance: 800-44-BIMBA 34

4. Gently insert the replacement probe into the cylinder, rotating it until it

slides through the hole in the piston. DO NOT FORCE THE PROBE INTO

THE CYLINDER. It should slide in freely with minimal friction. Hand

tighten until O-ring is seated, then rotate ONLY ¼ turn until with the ¼ inch

wrench. APPLYING TOO MUCH TORQUE WILL DAMAGE THE PROBE.

5. If there is a plug connector, slide it into the area in the rear cap.

6. Replace the rear cap and four cap screws using the torque in the table

below.

Bore Torque

(in-lbs.)

09 7

17 10

31 35

50 90

70 150

1 2 ... 29 30 31 32 33 34 35 36

Žádné komentáře

Bimba PCS Uživatelský manuál Strana 34